Sorry to have bothered you folks, and thanks again for taking the time to respond. I posted my question because there is not a stated solution to the original inquiry in this thread, and I thought if there was one, that solution may be relevant to my case. In my case, Flat Ceiling Over this Room was checked by default, Ceiling Finish was never set to "zero," and Ceiling Structure was never set to "zero." Yet, regardless of the changes I've made, the ceilings are still not displayed, and the underside of the "chipwood" floor is visible sans the joist structure, same as it is in the original post above. I also changed Ceiling Finish & Ceiling Structure measurements 20-or-more times (and others) including toggling check-boxes before posting my question. Chief Architect Minimum System Requirements. ![]() ![]() I read the help/instructional files several times, and I watched numerous YouTube videos per Eric's suggestion.and I even turned on my signature per his suggestion so my version is readily available, Thanks Eric. If you continue to experience difficulty with the software installation (either via software download or from physical media), then please contact us to continue troubleshooting while youre at the system experiencing the issue. ![]() In addition, I studied numerous other posts on this site and other sites. I did look for myself prior to posting my question, and I read the post very carefully many times, and I studied the settings for several hours, including the other relevant settings.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |